Kia Rio IV facelift (2020-2024) k-line signal interface Wiring diagram
This page shows the only wiring diagram for the component.k-line signal interface, which is found in the car Kia Rio IV facelift (2020-2024). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram k-line signal interface (1 of 1)
ANTENNA COIL
BLK WIRE
BLU WIRE
BLU/BLK WIRE
C-CAN
CLUSTER FUSE
COIL
COMPUTER DATA LINES SYSTEM
EMS
GRN WIRE
GROUND
GROUND SIG 1
HOT AT ALL TIMES
HOT IN ON OR START
I/P JUNCTION BLOCK
I/P-C
I/P-D
IGNITION KEY ILLUMINATION, DOOR WARNING SWITCH
IMMO DATA LINE
IMMO FUSE
IMMO IN
IMMO IND
IMMOBILIZER MODULE (TOP LEFT SIDE OF DASH)
IND
INPUT SIGNAL INTERFACE
INSTRUMENT CLUSTER
K LINE
K-LINE SIGNAL INTERFACE
MEM PWR
MICOM
MICRO CONTROLLER
NCA WIRE
ON/ST INPUT
ORG/ WIRE
PCM
PNK WIRE
POWER SUPPLY REGULATION
RED WIRE
SERIAL SIGNAL INTERFACE
SMART KEY 2 FUSE
TRANSCEIVER/
TRANSPONDER
TRANSPONDER READER IC
WHT WIRE
YEL WIRE
Go to component -> Immobilizer circuit, w/o smart key system -> K-LINE SIGNAL INTERFACE
