Kia Rio III (2011-2015) input signal interface Wiring diagram
This page shows the only wiring diagram for the component.input signal interface, which is found in the car Kia Rio III (2011-2015). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram input signal interface (1 of 1)
A/T M/T
ANTENNA COIL
BLK WIRE
BLU/BLK WIRE
CLUSTER FUSE
COMPT)
COMPUTER DATA LINES SYSTEM
DOOR WARNING SWITCH
ECM/PCM (LEFT REAR OF ENGINE
EGGG-AK EGGG-MK
GRN WIRE
HOT AT ALL TIMES
HOT AT ALL TIMES I/P JUNCTION BOX (BEHIND LEFT SIDE OF DASH)
HOT IN ON OR START
I/P-A
I/P-B
I/P-C
IMMO IND
IMMOBILIZER MODULE (LEFT TOP OF DASH)
INPUT SIGNAL INTERFACE
INSTRUMENT CLUSTER
K-LINE SIGNAL
MICOM
MICRO CONTROLLER
NCA WIRE
ORG/ WIRE
PDM 2 FUSE
PNK WIRE
POWER
POWER CONNECTOR
READER IC
RED WIRE
REGULATION
REGULATOR
ROOM LP FUSE
SERIAL SIGNAL
SUPPLY
TCU FUSE
TRANSPONDER
WHT WIRE
YEL WIRE
YEL/ORG WIRE
Go to component -> Immobilizer circuit, without smart key system -> INPUT SIGNAL INTERFACE
