Car Wiring Diagrams for Manual a/c circuit for Kia Rio II facelift (2009-2011)

1 2 3 ON INPUT BAT VOLT SENS GND 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 VENT DEF FD BK SIG ACT A/C CONTROL MODULE (BEHIND A/C CONTROL PANEL) A/CON 2 FUSE BLK WIRE BLK/ORG WIRE BLOWER RELAY BLOWER RESISTOR (BOTTOM OF HVAC UNIT) BLU WIRE BLU/BLK WIRE BLU/ORG WIRE BLW FUSIBLE BLWR OUT BRN WIRE BRN/ORG WIRE BWR IN BWR RLY ON ENGINE ROOM FUSE, RELAY BOX (AT LEFT REAR OF ENGINE COMPT) EVAPORATOR TEMPERATURE SENSOR (ON HVAC UNIT) GRN WIRE GRN/ORG WIRE GROUND 3 4 5 6 HIGH M/LOW LOW GRY WIRE HOT AT ALL TIMES HOT IN ON I/P JUNCTION BOX (UNDER LEFT SIDE OF DASH, I/P-E I/P-K II III IIII INTAKE ACT INTAKE ACTUATOR (ON HVAC UNIT) LINK M/HI 1 2 MODE ACTUATOR (BEHIND RIGHT CENTER OF DASH) MULT B/UP FUSE NCA WIRE OFF ORG/ WIRE PNK WIRE POWER CONNECTOR RED WIRE S/ROOF BLOWER FUSE SENS GND FRE REC ILL+ ILL- BLWR INPUT (HIGH) A/C PNK WIRE SENS SIGNAL A/C OUTPUT WHT WIRE YEL WIRE YEL/ORG WIRE

45 22 23 28 38 9 23 A/C CTRL RLY CTRL 77 35 PNK SIGNAL GROUND WIRE A/C COMPRESSOR (RIGHT FRONT OF ENGINE) A/C ON SIGNAL A/CON 1 FUSE A/CON RELAY A/T A/T M/T BLK WIRE BLU WIRE BLU/ORG WIRE BRN WIRE BRN/BLK WIRE BRN/ORG WIRE COND FUSIBLE LINK CONDENSER FAN MOTOR (BEHIND CONDENSER FAN RELAY 1 CONDENSER FAN RELAY 2 COOLING FAN MOTOR-2 (BEHIND RADIATOR) ECM (M/T) (LEFT REAR OF ENGINE COMPT) PCM ECU A FUSIBLE LINK ENGINE COOLANT TEMPERATURE SENSOR, SENDER (AT REAR OF ENGINE, ON CYLINDER HEAD) ENGINE ROOM FUSE, RELAY BOX (AT LEFT REAR OF ENGINE COMPT) FAN (HIGH) FAN (LOW) GRN WIRE GRN/ORG WIRE GRY WIRE HOT AT ALL TIMES HOT W/ MAIN RELAY ENERGIZED INPUT A/C PRESS SW INSTRUMENT CLUSTER MAIN RELAY NCA WIRE PNK WIRE POWER DISTRIBUTION SYSTEM RAD FUSIBLE LINK RADIATOR FAN RELAY RED WIRE RED/BLK WIRE RIGHT SIDE OF RADIATOR) SENDER SENSOR SNSR FUSE WHT WIRE