Kia Optima II (2005-2008) hot in on or start back up lamp fuse Wiring diagram
This page shows the only wiring diagram for the component.hot in on or start back up lamp fuse, which is found in the car Kia Optima II (2005-2008). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram hot in on or start back up lamp fuse (1 of 1)
7 8 9 PNK WIRE
BLK WIRE
BLU WIRE
BRN WIRE
BRN/WHT WIRE
CAMSHAFT POSITION SENSOR (ON REAR OF CYLINDER HEAD)
CRANKSHAFT POSITION SENSOR (ON FRONT OF ENGINE)
CRUISE CONTROL UNIT (AT RIGHT REAR CORNER OF ENGINE COMPT)
DOWN
ELECTRONIC POWER STEERING, INSTRUMENT CLUSTER SYSTEMS
ENGINE COMPARTMENT FUSE/RELAY BOX (AT LEFT SIDE OF ENGINE COMPT)
GRN WIRE
GRY WIRE
HOT IN ON OR START BACK UP LAMP FUSE
INSTRUMENT CLUSTER SYSTEM
JB-01
JB-03
JB-08
JB-09
JUNCTION BLOCK (JB) (BEHIND
JUNCTION BLOCK (JB) (BEHIND LEFT SIDE OF DASH)
MASS AIR FLOW SENSOR (IN AIR DUCT, BETWEEN AIR CLEANER, THROTTLE BODY)
NCA WIRE
PNK 1 2 WIRE
PNK 4 5 WIRE
PNK PNK PNK 7 8 9 WIRE
PNK PNK WIRE
PNK WIRE
RED WIRE
RED/BLK WIRE
SELECT
SPEED SENSOR (ON TOP OF TRANSAXLE)
SPORT MODE SWITCH
THROTTLE POSITION SENSOR (ON THROTTLE BODY)
WHT WIRE
YEL WIRE
Go to component -> Wiring diagram engine performance 2.4l, a/t early production (3 of 4) -> HOT IN ON OR START BACK UP LAMP FUSE
