Kia Optima II (2005-2008) fuel gauge sending unit wiring diagram
This page shows the only wiring diagram for the component.fuel gauge sending unit, which is found in the car Kia Optima II (2005-2008). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
fuel gauge sending unit wiring diagram (1 of 1)
10 JB-10
3 JB-13 PNK WIRE
ABS CONTROL UNIT (AT RIGHT REAR OF ENGINE COMPT)
BLK WIRE
BLK/ORG WIRE
BLU WIRE
BRAKE FLUID LEVEL SENSOR (ON BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY)
BRN WIRE
BRN/ORG WIRE
DIGITAL CLOCK
DIODE (UNDER LEFT SIDE OF DASH)
DRL UNIT (IF EQUIPPED) (AT RIGHT FRONT SIDE OF ENGINE COMPT)
ENGINE CONTROLS SYSTEM
ETACS
FUEL GAUGE SENDING UNIT
FUEL PUMP MOTOR
FUEL TANK
GRY WIRE
JB-01
JB-02
JB-13
JOINT CONNECTOR 15
JOINT CONNECTOR JC-06
JUNCTION BLOCK (JB) (BEHIND LEFT SIDE OF DASH)
LEFT REAR DOOR SWITCH (ON LEFT "C" PILLAR)
ORG/ WIRE
PARKING BRAKE SWITCH (AT BASE OF PARKING BRAKE LEVER)
PNK JB-10 WIRE
PNK WIRE
RIGHT FRONT DOOR SWITCH (ON RIGHT "B" PILLAR)
RIGHT REAR DOOR SWITCH (ON RIGHT "C" PILLAR)
THERMISTOR (CLOSED W/ LOW FUEL LEVEL)
W/ DRL
W/O DRL
YEL WIRE
Go to component -> Instrument cluster circuit, early production (2 of 2) -> FUEL GAUGE SENDING UNIT
