Kia Cadenza I facelift (2013-2016) spkr out+ Wiring diagram
This page shows the only wiring diagram for the component.spkr out+, which is found in the car Kia Cadenza I facelift (2013-2016). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram spkr out+ (1 of 1)
7 INCH TFT TFT MODULE DRIVER (TFT LED) IC
BLK WIRE
BLK/ORG WIRE
BLU/BLK WIRE
BOOST CONVERTER
BRN/ORG WIRE
C-CAN
C-CAN TRANSCEIVER
CENTER LEFT REAR PARKING ASSIST SENSOR (BEHIND CENTER LEFT SIDE OF REAR BUMPER)
CLUSTER SPEAKER
COMPUTER DATA LINES SYSTEM
CONSOLE SWITCH
DOT LCD (3.5 INCH) (DOT LCD)
GRN/ORG WIRE
GROUND
GRY WIRE
HIGH SPKR OUT-
HOT AT ALL TIMES
I/P-C
I/P-D
I/P-G
I/P-H
I/P-K
INSTRUMENT CLUSTER
IPM (LEFT END OF DASH)
IPS CONTROL MODULE C-CAN LOW HIGH
JOINT
JOINT CONNECTOR
LEAK CURRENT AUTOCUT DEVICE
LEFT "C" PILLAR)
LEFT REAR PARKING ASSIST SENSOR (BEHIND LEFT REAR END OF REAR BUMPER)
LID 1
LID 2
LIN
MEMORY 1 FUSE
MICOM
MODULE 2 FUSE
NCA WIRE
ORG/ WIRE
ORG/BLK WIRE
POWER
RED WIRE
RED/BLK WIRE
RELAY ENERGIZED
RIGHT REAR PARKING ASSIST SENSOR (BEHIND RIGHT REAR END OF REAR BUMPER)
RPAS LIN
RPAS OFF SW
RPAS OFF SW IND
RPAS SWITCH
S GND
SOUND GENERATOR
SPKR OUT+
YEL WIRE
Go to component -> Parking assistant circuit -> SPKR OUT+
