Kia Cadenza I facelift (2013-2016) rear htd relay control defogger sw in Wiring diagram
This page shows the only wiring diagram for the component.rear htd relay control defogger sw in, which is found in the car Kia Cadenza I facelift (2013-2016). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram rear htd relay control defogger sw in (1 of 1)
A/C CONTROL MODULE
AUTO DEF ACT CLOSE
AUTO DEF ACT F/B
AUTO DEF ACT OPEN
AUTO DEFOGGER SENSOR (TOP CENTER OF WINDSHIELD)
BLK WIRE
BLU WIRE
BRN WIRE
C-CAN HIGH
C-CAN LOW
COMPUTER DATA LINES SYSTEM
DEFOGGER
DEFOGGER SWITCH
DEICER FUSE
DEICER RELAY
DRIVER POWER OUTSIDE MIRROR DEFOGGER
E/R FUSE, RELAY BOX (LEFT REAR OF
ENGINE COMPT)
FRONT WIPER DEICER
GRN WIRE
GRY WIRE
HOT AT ALL TIMES
HOT IN ON OR START
HTD MIRR FUSE
I/P-B
I/P-C
I/P-D
I/P-F
I/P-H
IPM (LEFT END OF DASH)
IPS CONTROL MODULE
JOINT CONNECTOR
LEAK CURRENT AUTOCUT DEVICE
MEMORY 1 FUSE
MEMORY POWER
MODULE 2 FUSE
MULTI FUSE
NCA WIRE
OFF
ON IND.
ON/START IN
ORG/ WIRE
PASSENGER POWER OUTSIDE MIRROR
PNK WIRE
QUARTER PANEL GROUND
REAR DEFOGGER
REAR HTD RELAY CONTROL DEFOGGER SW IN
RED WIRE
RR HTD FUSE
RR HTD RELAY
SENS (PWM)
SENS GND
WHT WIRE
Go to component -> Defoggers circuit, with auto defogger -> REAR HTD RELAY CONTROL DEFOGGER SW IN
