Kia Cadenza I facelift (2013-2016) rear height sensor (right rear wheelwell) wiring diagram
This page shows the only wiring diagram for the component.rear height sensor (right rear wheelwell), which is found in the car Kia Cadenza I facelift (2013-2016). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
rear height sensor (right rear wheelwell) wiring diagram (1 of 1)
5 3 4 PWR GND SIG
ADAPTIVE FRONT LIGHTING MODULE (UNDER RIGHT SIDE OF DASH)
AFLS IND
BLK WIRE
BLK/ORG WIRE
BLU WIRE
BLU/ORG WIRE
BODY K-LINE LIN
BRN WIRE
C-CAN TRANSCEIVER
COMPUTER DATA LINES SYSTEM
FRONT HEIGHT SENSOR (RIGHT FRONT WHEELWELL)
FRONT SIGNAL C-CAN HIGH C-CAN LOW FRONT GROUND FRONT POWER ON/START INPUT
GRN WIRE
GROUND REAR SIG
HOT IN ON OR START
I/P-B
I/P-C
INSTRUMENT CLUSTER
INTERFACE
IPM (LEFT END OF DASH)
JOINT CONNECTOR
LEFT HEADLAMP
LEFT HEADLAMP LEVELING DEVICE ACTUATOR
LEVEL ISM
M-CAN TRANSCEIVER
MICOM
MODULE 2 FUSE
NCA WIRE
ORG/ WIRE
P-GND
PNK 13 9 14 WIRE
PNK WIRE
POWER DISTRIBUTION SYSTEM
REAR GROUND REAR POWER
REAR HEIGHT SENSOR (RIGHT REAR WHEELWELL)
RED WIRE
RED/BLK WIRE
RIGHT HEADLAMP
RIGHT HEADLAMP LEVELING DEVICE ACTUATOR
SWVEL ISM
YEL WIRE
YEL/ORG WIRE
Go to component -> Adaptive front lighting circuit -> REAR HEIGHT SENSOR (RIGHT REAR WHEELWELL)
