Kia Cadenza I facelift (2013-2016) intake actuator (upper left side of blower unit) wiring diagram
This page shows the only wiring diagram for the component.intake actuator (upper left side of blower unit), which is found in the car Kia Cadenza I facelift (2013-2016). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
intake actuator (upper left side of blower unit) wiring diagram (1 of 1)
A/CON FUSE
AMBIENT TEMPERATURE SENSOR (BEHIND CENTER OF FRONT FASCIA)
BLK WIRE
BLU WIRE
BLU/ORG WIRE
BRN WIRE
BRN/ORG WIRE
DRIVER TEMPERATURE ACTUATOR (LOWER LEFT SIDE OF HVAC UNIT)
EVAPORATOR SENSOR (LOWER RIGHT SIDE OF HVAC UNIT)
GRN WIRE
GRN/ORG WIRE
GRY WIRE
HOT AT ALL TIMES
HOT W/ ACC RELAY ENERGIZED IPM (LEFT END OF DASH) AUDIO FUSE
I/P-B
I/P-C
INTAKE ACTUATOR (UPPER LEFT SIDE OF BLOWER UNIT)
JOINT CONNECTOR
LEAK CURRENT AUTOCUT DEVICE
MEMORY 1 FUSE
MODE ACTUATOR (UPPER LEFT SIDE OF HVAC UNIT)
MODULE 2 FUSE
ORG GRN/ORG WIRE
ORG/ WIRE
PNK 19 20 WIRE
PNK 4 5 WIRE
PNK 7 8 9 WIRE
PNK PNK PNK WIRE
PNK PNK WIRE
PNK WIRE
RED WIRE
RED/ORG WIRE
RELAY ENERGIZED
WHT WIRE
WHT/BLK WIRE
YEL WIRE
Go to component -> Automatic a/c circuit (2 of 3) -> INTAKE ACTUATOR (UPPER LEFT SIDE OF BLOWER UNIT)
