Kia Cadenza I facelift (2013-2016) etc motor, throttle position sensor (integral to etc module) wiring diagram
This page shows the only wiring diagram for the component.etc motor, throttle position sensor (integral to etc module), which is found in the car Kia Cadenza I facelift (2013-2016). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
etc motor, throttle position sensor (integral to etc module) wiring diagram (1 of 1)
ACCEL PEDAL POSITION SENSOR (ABOVE ACCELERATOR PEDAL ASSEMBLY)
BLK WIRE
BLU WIRE
BRAKE SWITCH FUSE
BRN WIRE
COMPUTER DATA LINES SYSTEM
E/R-ELGB
ECU 2 FUSE
EMS BOX (ON IPM)
ETC MOTOR, THROTTLE POSITION SENSOR (INTEGRAL TO ETC MODULE)
GRN WIRE
GRY WIRE
HOT AT ALL TIMES
I/P-B
I/P-C
I/P-F
I/P-G
IPM (LEFT END OF DASH) IPS CONTROL
JOINT CONNECTOR
MODULE 2 FUSE
MODULE 3 FUSE
MOTOR
ORG/ WIRE
PCM (LEFT REAR OF ENGINE COMPT)
RED WIRE
RELAY ENERGIZED
SMART KEY CONTROL MODULE (RIGHT CENTER OF DASH)
STOP LAMP SWITCH (ABOVE BRAKE PEDAL, ON BRACKET)
STOP SIG
THROTTLE POSITION SENSOR
WHT WIRE
WHT/ORG WIRE
YEL WIRE
YEL/ORG WIRE
Go to component -> Cruise control circuit (1 of 3) -> ETC MOTOR, THROTTLE POSITION SENSOR (INTEGRAL TO ETC MODULE)
