Kia Cadenza I facelift (2013-2016) c-can transceiver (tft lcd) hold tft module wiring diagram
This page shows the only wiring diagram for the component.c-can transceiver (tft lcd) hold tft module, which is found in the car Kia Cadenza I facelift (2013-2016). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
c-can transceiver (tft lcd) hold tft module wiring diagram (1 of 1)
ABS 1 FUSE
BLK WIRE
BLK/ORG WIRE
BLU/RED WIRE
BRAKE FLUID LEVEL SENSOR (ON BRAKE FLUID RESERVOIR) JOINT CONNECTOR
BRAKE IND
BRAKE SW FUSE
BRN WIRE
C-CAN TRANSCEIVER (TFT LCD) HOLD TFT MODULE
CAN HIGH
CAN LOW
COMPUTER DATA LINES SYSTEM
DOT LCD
E/R FUSE, RELAY BOX (LEFT REAR OF ENGINE COMPT)
ESC ABS IND IND
ESC AUTO HOLD IND OFF IND
ESS SIG
GRN WIRE
GROUND
HAC/DBC SIG
HOT AT ALL TIMES
I/P-B
IGN
INPUT CIRCUIT
INSTRUMENT CLUSTER
INTERFACE
INTERNAL CONTROL
IPM (LEFT END OF DASH)
IPS
JOINT
LEFT FRONT WHEEL SENSOR (LEFT FRONT WHEEL HUB ASSEMBLY)
MEMORY POWER
MICOM
MULTI FUSE
NCA WIRE
NOT USED
ORG/ WIRE
PNK WIRE
PWR
RED WIRE
RED/BLK WIRE
RELAY ENERGIZED
STOP ABS 2 FUSE LAMP 1 FUSE
STOP LAMP 2 FUSE
STOP LAMP SWITCH (ABOVE BRAKE PEDAL, ON BRACKET)
STOP LMP SW
STOP LP
STOP LP SIG
STOP SIGNAL ELECTRONIC MODULE (RIGHT SIDE OF DASH)
TFT DRIVER IC AUTO
WHT WIRE
WHT/RED WIRE
YEL WIRE
YEL/ORG WIRE
Go to component -> Anti-lock brakes circuit, standard (2 of 2) -> C-CAN TRANSCEIVER (TFT LCD) HOLD TFT MODULE
