Jeep Wrangler II (1996-2006) hot all times wiring diagram
This page shows the only wiring diagram for the component.hot all times, which is found in the car Jeep Wrangler II (1996-2006). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
hot all times wiring diagram (1 of 1)
43 7 46 PCI BUS SCI TRANSMIT SCI RECEIVE PNK WIRE
A/T
AIR BAG CONTROL MODULE (FRONT OF FLOOR PAN TUNNEL)
BLK/LT GRN WIRE
BLK/TAN WIRE
CONTROLLER ANTI-LOCK BRAKE (AT LEFT REAR CORNER OF ENGINE COMPT)
DATA LINK CONNECTOR (BOTTOM LEFT END OF DASH)
FLASH ENABLE
FUSE 26
HOT ALL TIMES
INSTRUMENT CLUSTER
LT GRN WIRE
LT GRN/PNK WIRE
LT GRN/WHT WIRE
PCI BUS
PCI BUS (NEAR BREAKOUT TO STEERING COLUMN)
PNK M/T WIRE
PNK PNK A/T WIRE
PNK SCI TRANSMIT WIRE
PNK WIRE
PNK/WHT WIRE
POWER DISTRIBUTION CENTER (ON RIGHT SIDE OF ENGINE COMPARTMENT)
POWERTRAIN CONTROL MODULE (IN RIGHT REAR OF ENGINE COMPT, ON FIREWALL)
RADIO
SCI RECEIVE
SENTRY KEY IMMOBILIZER MODULE (ON STEERING COLUMN, NEAR IGNITION LOCK CYLINDER)
TRANSMISSION CONTROL MODULE (ON LEFT FENDER SHIELD)
VIO WIRE
VIO/YEL WIRE
WHT/BRN WIRE
YEL WIRE
Go to component -> Computer data lines circuit -> HOT ALL TIMES
