Jeep Wrangler II (1996-2006) g-switch (in front console/shifter, mounted to bracket on floor pan) wiring diagram
This page shows the only wiring diagram for the component.g-switch (in front console/shifter, mounted to bracket on floor pan), which is found in the car Jeep Wrangler II (1996-2006). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
g-switch (in front console/shifter, mounted to bracket on floor pan) wiring diagram (1 of 1)
ABS SYSTEM RLY CTRL RR WHEEL SPD SENS + RF WHEEL SPD SENS -
ABS WARNING IND
ANTI-LOCK BRAKE RELAY (IN POWER DISTRIBUTION CENTER)
BLK WIRE
BLK/PNK WIRE
BRAKE LAMP SWITCH (ON BRACKET, ABOVE BRAKE PEDAL)
CONTROLLER ANTI-LOCK BRAKE (AT LEFT REAR CORNER OF ENG COMPT)
DK BLU WIRE
FUSE 10
FUSE 12
FUSE 2
FUSE 7
FUSE 8
FUSE BLOCK (UNDER RIGHT CENTER OF DASH)
FUSED IGN (RUN) GROUND FUSE B (+)
G-SWITCH (IN FRONT CONSOLE/SHIFTER, MOUNTED TO BRACKET ON FLOOR PAN)
GRY/BLK WIRE
HOT AT ALL TIMES
HOT IN
HOT IN RUN, START
INSTRUMENT CLUSTER
LEFT FRONT WHEEL SPEED SENSOR (LEFT SIDE OF ENGINE COMPT)
LEFT REAR WHEEL SPEED SENSOR (NEAR VEHICLE SPEED SENSOR BREAKOUT)
LT GRN WIRE
LT GRN/DK BLU WIRE
LT GRN/ORG WIRE
M/T A/T
ORG/ WIRE
PNK PNK WIRE
PNK SCI TRANSMIT SCI TRANSMIT WIRE
PNK SCI TRANSMIT WIRE
PNK WIRE
PNK/ORG WIRE
POWER DISTRIBUTION CENTER (ON RIGHT SIDE OF ENGINE COMPT)
POWERTRAIN CONTROL MODULE (IN RIGHT REAR OF ENG COMPT, ON FIREWALL)
RED WIRE
RED/DK BLU WIRE
RED/DK GRN WIRE
RIGHT FRONT WHEEL SPEED SENSOR
RIGHT REAR WHEEL SPEED SENSOR (NEAR VEHICLE SPEED SENSOR BREAKOUT)
RUN WIRE
TAN WIRE
TAN/WHT WIRE
TRANSMISSION CONTROL MODULE (ON LEFT FENDER SHIELD)
VIO WIRE
VIO/WHT WIRE
WHT WIRE
WHT/DK BLU WIRE
WHT/TAN WIRE
YEL WIRE
YEL/DK BLU WIRE
YEL/VIO WIRE
Go to component -> Anti-lock brakes circuit -> G-SWITCH (IN FRONT CONSOLE/SHIFTER, MOUNTED TO BRACKET ON FLOOR PAN)
