Jeep Liberty I (2001-2007) gen fld cntrl wiring diagram
This page shows the only wiring diagram for the component.gen fld cntrl, which is found in the car Jeep Liberty I (2001-2007). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
gen fld cntrl wiring diagram (1 of 1)
5-VOLT
A/C PRESS SEN
ACCELERATOR PEDAL POSITION SENSOR (BASE OF PEDAL)
ASD RLY OUT
AUTO SHUT DOWN RELAY
BLK WIRE
BLOWER MOTOR RELAY
BRN WIRE
BRN/DK BLU WIRE
BRN/DK GRN WIRE
BRN/LT BLU WIRE
BRN/LT GRN WIRE
BRN/ORG WIRE
BRN/PNK WIRE
BRN/RED WIRE
BRN/VIO WIRE
BRN/WHT WIRE
BRN/YEL WIRE
CAN C BUS (+)
COMPUTER DATA LINES SYSTEM
DK GRN/LT GRN WIRE
EOP SENS IG
FL LEV SEN SIG
FRONT CONTROL MODULE
FUEL HEATER (LEFT REAR OF ENGINE COMPT)
FUEL HEATER RELAY
FUSE 11
FUSE 16
FUSE 26
FUSE 6
GEN FLD CNTRL
GROUND
GROUND 1
GROUND 2
HOT AT ALL TIMES
PCI BUS
PNK/GRY WIRE
PNK/WHT WIRE
POWER DISTRIBUTION CENTER (ON LEFT SIDE OF ENGINE COMPT)
RED WIRE
SCI TRANSMIT
SEN GROUND
SIG (1)
SIG (2)
STARTING/ CHARGING SYSTEM
TRANSMISSION CONTROL MODULE (RIGHT REAR OF ENGINE COMPT)
TRQ REQ SEN
VIO/BRN WIRE
WATER IN FUEL SENSOR (LEFT REAR OF ENGINE COMTP)
WHT/BRN WIRE
WHT/GRY WIRE
WHT/LT GRN WIRE
WHT/VIO WIRE
WTR IN FUEL SEN
Go to component -> Wiring diagram engine performance 2.8l diesel (3 of 4) -> GEN FLD CNTRL
