Jeep Commander I (2005-2010) backup lamp ground feed Wiring diagram
This page shows the only wiring diagram for the component.backup lamp ground feed, which is found in the car Jeep Commander I (2005-2010). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram backup lamp ground feed (1 of 1)
1 3 B (+) IGN SW
34 35 CAN C BUS (+) CAN C BUS (-)
BACKUP LAMP
BACKUP LAMP FEED
BACKUP LAMP GROUND FEED
BACKUP LICENSE PLATE LAMP/ REAR CAMERA ASSEMBLY LAMP FEED
BLK WIRE
BRN WIRE
CAN C BUS (+)
COMPUTER DATA LINES SYSTEM
DK GRN WIRE
DK GRN/YEL WIRE
EXCEPT 3.7L
FUSE 37
FUSED IGN SW OUT (RUN-START)
HOT AT ALL TIMES POWER DISTRIBUTION CENTER (LEFT SIDE OF ENGINE COMPT)
INSIDE REARVIEW MIRROR
IPM
LEFT TAIL/ STOP/TURN LAMP
LT BLU WIRE
LT GRN WIRE
PNK WIRE
PNK/WHT WIRE
POWERTRAIN CONTROL MODULE (LEFT SIDE OF ENGINE COMPT)
REAR VIDEO CAMERA (EXCEPT BASE)
RED WIRE
RIGHT TAIL/ STOP/TURN LAMP
SHIFTER LEVER ASSEMBLY
TAN WIRE
TRAILER TOW 7-WAY WIRING (UNDER REAR OF VEHICLE)
TRANSMISSION SOLENOID/ TRS ASSEMBLY (EXCEPT 3.7L) (LEFT SIDE OF TRANSMISSION)
W/ REAR CAMERA W/O HANDS FREE W/ HANDS FREE
WHT WIRE
WHT/LT BLU WIRE
WHT/LT GRN WIRE
WIRELESS IGNITION NODE
Go to component -> Backup lamps circuit -> BACKUP LAMP GROUND FEED
