Jeep Cherokee III facelift (2004-2007) dhs pressure sensor (front of frame) wiring diagram
This page shows the only wiring diagram for the component.dhs pressure sensor (front of frame), which is found in the car Jeep Cherokee III facelift (2004-2007). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
dhs pressure sensor (front of frame) wiring diagram (1 of 1)
1 2 3 DHS SENSOR SENSOR SIG
9 11 12 8 6 7 GROUND CAN C BUS (+) CAN C BUS (-) DHS SENSOR SENSOR SIG
BLK WIRE
BRN WIRE
COMPUTER DATA LINES SYSTEM
DHS PRESSURE CONTROL SOLENOID (FRONT OF FRAME)
DHS PRESSURE SENSOR (FRONT OF FRAME)
DIRECTIONAL CONTROL VALVE B SOLENOID (FRONT OF FRAME)
DIRECTIONAL CONTROL VALVE G SOLENOID (FRONT OF FRAME)
DK GRN WIRE
FINAL DRIVE CONTROL MODULE (BELOW LEFT REAR SEAT)
FUSE
GRY WIRE
GRY/BRN WIRE
GRY/DK GRN WIRE
GRY/LT BLU WIRE
GRY/TAN WIRE
GRY/WHT WIRE
GRY/YEL WIRE
HOT AT ALL TIMES
INTEGRATED POWER MODULE (LEFT SIDE OF ENGINE COMPARTMENT)
LT BLU WIRE
POWER DISTRIBUTION CENTER (LEFT SIDE OF ENGINE COMPARTMENT)
RED WIRE
RED/TAN WIRE
TAN WIRE
WHT/LT BLU WIRE
WHT/LT GRN WIRE
Go to component -> Electronic suspension circuit -> DHS PRESSURE SENSOR (FRONT OF FRAME)
