Jaguar XKR I (1998-2004) stability/ traction state wiring diagram
This page shows the only wiring diagram for the component.stability/ traction state, which is found in the car Jaguar XKR I (1998-2004). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
stability/ traction state wiring diagram (1 of 1)
ABS/TRACTION CONTROL MODULE (LEFT FRONT SIDE OF ENGINE COMPARTMENT)
BLK WIRE
BLU WIRE
BLU/YEL WIRE
BRAKE FLUID RESERVOIR (BRAKE BOOSTER ENCLOSURE IN ENGINE COMPARTMENT)
BRAKE SWITCH (NEAR TOP OF BRAKE PEDAL)
BRN WIRE
BRN/RED WIRE
BRN/WHT WIRE
CENTER CONSOLE SWICH PACK
COMPUTER DATA LINES SYSTEM
DRIVER'S SIDE FUSE BOX (BEHIND LEFT SIDE OF DASH)
ENGINE COMPARTMENT FUSE BOX (IN LEFT FRONT OF ENGINE COMPARTMENT)
FUSE 16
FUSE 18
FUSE 4
FUSE 6
GRN WIRE
HOT AT ALL TIMES
HOT IN RUN, START
IGNITION SWITCH
INPUT B
INPUT INPUT DATA - OUTPUT INPUT SIG GND OUTPUT B+ INPUT SIG GND
LEFT FRONT WHEEL SPEED SENSOR (LEFT FRONT WHEEL HUB ASSEMBLY)
LEFT REAR WHEEL SPEED SENSOR (LEFT REAR WHEEL HUB ASSEMBLY)
NCA WIRE
OFF (0)
ORG/ WIRE
ORG/GRN WIRE
PNK WIRE
RED WIRE
RED/WHT WIRE
RIGHT FRONT WHEEL SPEED SENSOR (RIGHT FRONT WHEEL HUB ASSEMBLY)
RIGHT REAR WHEEL SPEED SENSOR (RIGHT REAR WHEEL HUB ASSEMBLY)
RUN WIRE
STABILITY/ TRACTION CONTROL SWITCH
STABILITY/ TRACTION STATE
WHT WIRE
WHT/BLU WIRE
YEL WIRE
Go to component -> Anti-lock brake circuits -> STABILITY/ TRACTION STATE
