Jaguar XJS Series 3 (1990-1996) hot in on and start Wiring diagram
This page shows the only wiring diagram for the component.hot in on and start, which is found in the car Jaguar XJS Series 3 (1990-1996). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram hot in on and start (1 of 1)
ABS CONTROL MODULE (LEFT REAR TRUNK WHEEL ARCH)
ABS DIAGNOSTIC CONNECTOR (LEFT REAR TRUNK WHEEL ARCH)
ABS IND.
ABS PUMP (RIGHT FRONT BULKHEAD)
BLK WIRE
BLK/LT GRN WIRE
BLK/YEL WIRE
BLU/GRN WIRE
BRK IND
BRN/BLU WIRE
BRN/GRN WIRE
BRN/GRY WIRE
BRN/ORG WIRE
BRN/PNK WIRE
COMBINED PRESSURE SWITCH (NO PRESSURE STATE) (BRAKE PUMP UNIT)
FUSE 11
FUSE 22
GRN WIRE
GRN/BLK WIRE
GRN/BRN WIRE
GRN/PPL WIRE
GRN/RED WIRE
GRN/WHT WIRE
HOT AT ALL TIMES
HOT IN ON AND START
IGNITION SWITCH
INSTRUMENT PACK
LEFT FRONT
LEFT REAR WHEEL SPEED SENSOR RIGHT FRONT WHEEL SPEED SENSOR
LT GRN/YEL WIRE
MAIN RELAY (LEFT REAR TRUNK WHEEL ARCH)
MAIN VALVE (FRONT OF BRAKE ACTUATOR)
MTR PUMP UNIT R OUTLET VLV RF OUTLET VLV LF INLET VLV
MULTI FUNCTION UNIT (RIGHT COMPONENT PANEL)
NCA WIRE
OFF
OUT
PPL
PPL/GRN WIRE
PUMP RELAY (RIGHT COMPONENT PANEL)
PUMP RLY RF INLET VLV LF OUTLET VLV R INLET VLV MAIN VLV IG PWR MAIN RLY
REAR
RED/BLK WIRE
RED/YEL WIRE
RESERVOIR (FULL STATE) (TOP OF BRAKE ACTUATOR)
RIGHT FRONT
RIGHT FUSE PANEL (RIGHT COMP PANEL) FUSE 19
RIGHT FUSE PANEL (RIGHT COMPONENT PANEL)
RIGHT REAR WHEEL SPEED SENSOR LEFT FRONT WHEEL SPEED SENSOR
RR SENSOR LF SENSOR LR SENSOR RF SENSOR DIAGNOSTIC DIAGNOSTIC
RUN WIRE
STOP LAMP RELAY (ABOVE ABS CONTROL MODULE)
STOP LAMP SWITCH (TOP OF BRAKE PEDAL SUPPORT)
TO AUX. LOAD RELAY
VALVE BLOCK (SIDE OF BRAKE ACTUATOR)
WHT WIRE
WHT/BLU WIRE
WHT/BRN WIRE
WHT/GRN WIRE
WHT/PNK WIRE
WHT/PPL WIRE
WHT/YEL WIRE
YEL/GRN WIRE
Go to component -> Anti-lock brake circuits -> HOT IN ON AND START
