Jaguar S-type I facelift (2004-2008) dynamic stability control module (at right front of eng compt, near abs) wiring diagram
This page shows the only wiring diagram for the component.dynamic stability control module (at right front of eng compt, near abs), which is found in the car Jaguar S-type I facelift (2004-2008). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
dynamic stability control module (at right front of eng compt, near abs) wiring diagram (1 of 1)
BLK WIRE
BLU WIRE
BRN/GRN WIRE
CONTROLS: MOTOR, SENSORS,, RELAY
DRIVER DOOR CONTROL MODULE (IN DRIVER DOOR)
DRIVER WINDOW MOTOR ASSEMBLY
DYNAMIC STABILITY CONTROL MODULE (AT RIGHT FRONT OF ENG COMPT, NEAR ABS)
FUSE 28
GLOBAL CLOSE SIG
HOT AT ALL TIMES
LEFT REAR WINDOW MOTOR ASSEMBLY
PASSENGER WINDOW MOTOR ASSEMBLY
REAR POWER DISTRIBUTION FUSE BOX (ON RIGHT SIDE OF TRUNK)
RIGHT REAR WINDOW MOTOR ASSEMBLY
ROOF CONSOLE
SLIDING ROOF CONTROL MODULE
SLIDING ROOF SWITCH
WHT/BLU WIRE
WINDOW ENABLE
YEL/BLU WIRE
YEL/GRN WIRE
YEL/RED WIRE
Go to component -> Power top/sunroof circuit -> DYNAMIC STABILITY CONTROL MODULE (AT RIGHT FRONT OF ENG COMPT, NEAR ABS)
