Isuzu VehiCross I (1997-2001) hot in start cb-1 Wiring diagram
This page shows the only wiring diagram for the component.hot in start cb-1, which is found in the car Isuzu VehiCross I (1997-2001). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram hot in start cb-1 (1 of 1)
A/C TRIPLE PRESSURE SWITCH (BEHIND LEFT SIDE OF RADIATOR GRILLE)
ANTI-THEFT AND KEYLESS ENTRY CONTROL UNIT (LEFT OF STEERING COLUMN)
BLK WIRE
BLK/WHT WIRE
BLOWER MOTOR (BELOW RIGHT SIDE OF DASH)
BLOWER RESISTOR (BEHIND GLOVE BOX)
BLU WIRE
BLU/BLK WIRE
BLU/RED WIRE
BRN WIRE
DASH FUSE BOX (BEHIND LEFT DASH TRIM PANEL)
EB-16 MAIN FUSE
EB-5 A/C FUSE
EB-6 BLOWER FUSE
EVAPORATOR TEMPERATURE SENSOR
FAN CONTROL SWITCH
FUSE
FUSE/RELAY BOX (ON RIGHT SIDE OF ENGINE COMPARTMENT)
GENERATOR
GRN WIRE
GRN/RED WIRE
GRN/WHT WIRE
HEATER-A/C CONTROL PANEL
HEATER-A/C RELAY
HOT AT ALL TIMES
HOT IN START CB-1
ILLUM
J/C
LT GRN WIRE
LT GRN/BLK WIRE
OFF
ORG/ WIRE
PNK WIRE
PNK/WHT WIRE
RED WIRE
STARTER CUT RELAY
STARTING SYSTEM
THERMO FUSE
WHT WIRE
WHT/GRN WIRE
WHT/RED WIRE
Go to component -> Manual a/c circuit (2 of 2) -> HOT IN START CB-1
