Isuzu Trooper II (1992-2002) reverse or l range output 45 e-22 Wiring diagram
This page shows the only wiring diagram for the component.reverse or l range output 45 e-22, which is found in the car Isuzu Trooper II (1992-2002). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram reverse or l range output 45 e-22 (1 of 1)
A/T
ABS ACTIVE INPUT
ABS IND.
BACK-UP LIGHT SWITCH (ON RIGHT SIDE OF TRANS- MISSION)
BLK WIRE
BLU WIRE
BLU/WHT WIRE
BRAIDED WIRE
BRAKE SWITCH (ON BRAKE PEDAL SUPPORT)
C-10 METER GAUGE FUSE
C-14 STOPLIGHT A/T CONT FUSE
C-3 TURN BACK FUSE
C-4 ELEC. IGN. FUSE
DASH FUSE BOX (BEHIND LEFT KICK PANEL)
DIODE BOX A
ELECTRONIC BRAKE CONTROL MODULE (EBCM) (RIGHT FRONT OF ENGINE COMPARTMENT)
EXTERIOR LIGHTS
F-9 ABS FUSE
FL-6 (ABS 4/WHEEL ONLY) FUSE
FUSE/RELAY BOX (ON RIGHT SIDE OF ENGINE COMPARTMENT)
G SENSOR- ABS (REAR OF PARK BRAKE LEVER)
GND BATTERY BATTERY GROUND ABS IND LT CTRL DLC INPUT/OUTPUT
GRN WIRE
GRN/YEL WIRE
GRY WIRE
HOT AT ALL TIMES
HOT IN ON OR START
I-10
IGNITION
LEFT FRONT ABS SPEED SENSOR (INSIDE OF LEFT FRONT WHEEL)
LEFT REAR ABS SPEED SENSOR (INSIDE OF LEFT REAR WHEEL)
LT GRN/RED WIRE
M/T
METER ASSEMBLY
NCA WIRE
ORG/ WIRE
ORG/BLK WIRE
ORG/BLU WIRE
ORG/GRN WIRE
ORG/WHT WIRE
PNK OUTPUT B-48 WIRE
POWERTRAIN CONTROL MODULE (PCM) (BEHIND CENTER OF DASH, BELOW RADIO)
RED WIRE
RED/BLU WIRE
REVERSE OR L RANGE OUTPUT 45 E-22
RIGHT FRONT ABS SPEED SENSOR (INSIDE OF RIGHT FRONT WHEEL)
RIGHT REAR ABS SPEED SENSOR (INSIDE OF RIGHT REAR WHEEL)
TORQUE ON DEMAND (TOD) CONTROL UNIT (BENEATH FRONT PASSENGER'S SEAT)
VIO/WHT WIRE
WHT WIRE
WHT/BLU WIRE
WHT/GRN WIRE
YEL WIRE
YEL/BLK WIRE
YEL/GRN WIRE
Go to component -> Anti-lock brake circuits -> REVERSE OR L RANGE OUTPUT 45 E-22
