Isuzu Rodeo II (1998-2004) transmission speed sensor shield wiring diagram
This page shows the only wiring diagram for the component.transmission speed sensor shield, which is found in the car Isuzu Rodeo II (1998-2004). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
transmission speed sensor shield wiring diagram (1 of 1)
3.2L
ACCELERATION POSITION SENSOR ASSEMBLY SHIELD
BLK WIRE
BLU WIRE
C-34
CRANKSHAFT POSITION SENSOR (CKP) SHIELD
DATA LINK CONNECTOR
E-16
E-21
E-21 E-22
E-22
E-28 (LEFT SIDE OF INTAKE MANIFOLD)
E-29 (LEFT SIDE OF INTAKE MANIFOLD)
E-30 (RIGHT SIDE OF INTAKE MANIFOLD)
E-33
E-57
E-6
E-60
E-61
ECM OR PCM
EGR SOLENOID VALVE
HEATED OXYGEN SENSOR (BANK 1 SENSORS 1, 2) SHIELD
HEATED OXYGEN SENSOR (BANK 2 SENSORS 1, 2) SHIELD
IGNITION COILS 1, 3, 5 SHIELD
IGNITION COILS 2, 4, 6 SHIELD
ION SENSING MODULE
MAF SENSOR
MASS AIR FLOW (MAF) SENSOR SHIELD
MOTOR ACTUATOR
PNK WIRE
RED/BLK WIRE
THROTTLE VALVE ASSEMBLY ASSEMBLY SHIELD
THROTTLE VALVE ASSEMBLY SHIELD
TRANSFER SWITCH
TRANSMISSION SPEED SENSOR SHIELD
VEHICLE SPEED SENSOR
YEL WIRE
Go to component -> Ground distribution circuit (2 of 4) -> TRANSMISSION SPEED SENSOR SHIELD
