Isuzu Rodeo II (1998-2004) shift-on-the-fly controller (lower left center of dash) wiring diagram
This page shows the only wiring diagram for the component.shift-on-the-fly controller (lower left center of dash), which is found in the car Isuzu Rodeo II (1998-2004). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
shift-on-the-fly controller (lower left center of dash) wiring diagram (1 of 1)
1 2 3 4 5 6 FRT AXLE ACT FRT AXLE ACT IGNITION FRT AXLE ENGAGE
12 13 14 15 16 IGN
5 6 7 8 ON/OFF IN AXLE ENGAGED TRANS COMPLETE FRT AXLE ENGAGE
ACTUATOR
ANTI-LOCK BRAKES
BLK WIRE
BLU WIRE
BLU/ORG WIRE
BLU/RED WIRE
BLU/WHT WIRE
BRN WIRE
BRN/BLU WIRE
BRN/RED WIRE
BRN/WHT WIRE
BRN/YEL WIRE
C-16 (REAR OF LEFT FRONT FENDER)
DASH FUSE BOX (BEHIND DASH, LEFT OF STEERING COLUMN)
E-30 (RIGHT SIDE OF INTAKE MANIFOLD)
FRONT AXLE ACTUATOR (LEFT SIDE OF FRONT AXLE)
FUSE 11 METER
FUSE 14 BACK UP/ TURN LIGHT
GRN WIRE
GRN/RED WIRE
GROUND
HOT IN ON
HOT IN ON OR START
I-1
ILLUM
IND
METER ASSEMBLY
OFF
ORG/ WIRE
RED WIRE
RED/BLK WIRE
RED/GRN WIRE
SHIFT-ON-THE-FLY CONTROLLER (LOWER LEFT CENTER OF DASH)
SWITCH
WHT WIRE
WHT/GRN WIRE
YEL WIRE
YEL/GRN WIRE
Go to component -> 3.2l, 4wd circuit, shift on the fly -> SHIFT-ON-THE-FLY CONTROLLER (LOWER LEFT CENTER OF DASH)
