Isuzu Rodeo II (1998-2004) multiplex control unit (under rear of center console) wiring diagram
This page shows the only wiring diagram for the component.multiplex control unit (under rear of center console), which is found in the car Isuzu Rodeo II (1998-2004). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
multiplex control unit (under rear of center console) wiring diagram (1 of 1)
BLK WIRE
DATA LINK CONNECTOR (DLC) (LOWER LEFT SIDE OF DASH)
E-30 (RIGHT SIDE OF INTAKE MANIFOLD)
ELECTRONIC BRAKE CONTROL MODULE (RIGHT REAR CORNER OF ENGINE COMPT)
ENGINE OR POWERTRAIN CONTROL MODULE (LEFT REAR OF ENGINE COMPARTMENT)
FUSE 2 HORN
FUSE/ RELAY BOX (RIGHT SIDE OF ENGINE COMPT)
GRN WIRE
GRN/WHT WIRE
GRY WIRE
HOT AT ALL TIMES
INTELLIGENT SUSPENSION CONTROL UNIT (BELOW CENTER OF DASH)
LT GRN WIRE
MULTIPLEX CONTROL UNIT (UNDER REAR OF CENTER CONSOLE)
ORG/ WIRE
ORG/BLK WIRE
RED WIRE
RED/WHT WIRE
SENSING, DIAGNOSTIC MODULE (BELOW CENTER OF DASH)
WHT WIRE
YEL WIRE
YEL/BLK WIRE
Go to component -> 3.2l, computer data lines -> MULTIPLEX CONTROL UNIT (UNDER REAR OF CENTER CONSOLE)
