Isuzu Rodeo II (1998-2004) lock off on wiring diagram
This page shows the only wiring diagram for the component.lock off on, which is found in the car Isuzu Rodeo II (1998-2004). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
lock off on wiring diagram (1 of 1)
A/T
AUTOMATIC TRANSMISSION MODE SWITCH (ON LEFT SIDE OF TRANS)
BATTERY
BLK WIRE
BLK/BLU WIRE
BLK/GRN WIRE
BLK/WHT WIRE
BLK/YEL WIRE
CLUTCH
DASH FUSE BOX (BEHIND DASH, LEFT OF STEERING COLUMN)
FUSE CB-12 ENGINE IG
FUSE CB-3 STARTER
FUSE EB-16 MAIN FUSE EB-19
FUSE/ RELAY BOX (RIGHT SIDE OF ENGINE COMPT)
FUSE/RELAY BOX (RIGHT SIDE OF ENGINE COMPT)
HOT IN ON OR START
JUNCTION CONNECTOR A
KEYLESS ENTRY, ANTI-THEFT CONTROL UNIT (W/ ANTI-THEFT) (ABOVE RIGHT KICK PANEL)
LOCK OFF ON
M/T
P-10 (LOWER RIGHT FRONT OF ENGINE)
P-2
P-3
P-4
P-6/C-36 (RIGHT SIDE OF ENGINE COMPT, BEHIND BATTERY)
PNK STR FEED E-21 WIRE
RED WIRE
RED/YEL WIRE
RLY CTRL E-21 ENGINE OR POWERTRAIN CONTROL MODULE (LEFT REAR OF ENGINE COMPT)
RLY CTRL E-22
STARTER
STARTER MOTOR
STARTER RELAY
STARTER SOLENOID
STARTER SWITCH
SWITCH (CLUTCH PEDAL SUPPORT)
WHT WIRE
WHT/BLK WIRE
WHT/BLU WIRE
WHT/GRN WIRE
YEL WIRE
Go to component -> 3.2l, starting circuit -> LOCK OFF ON
