Infiniti QX80 I (2013-2014) air bag diagnosis sensor unit Wiring diagram
This page shows the only wiring diagram for the component.air bag diagnosis sensor unit, which is found in the car Infiniti QX80 I (2013-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram air bag diagnosis sensor unit (1 of 1)
A/C AUTOMATIC AMPLIFIER (UNDER CENTER OF DASH)
A/T ASSEMBLY
ABS ACTUATOR, ELECTRIC UNIT (CONTROL UNIT)
ACCELERATOR PEDAL ACTUATOR (ABOVE ACCELERATOR PEDAL BRACKET)
AFS CONTROL UNIT (BEHIND RIGHT SIDE OF DASH)
AIR BAG DIAGNOSIS SENSOR UNIT
BCM (BODY CONTROL MODULE) (UNDER LEFT SIDE OF DASH)
BLK WIRE
BLU WIRE
CAN COMM LINE
CAN COMM LINE ECM COMM LINE
CAN L
CAN-H
COMBINATION METER
COMM
DATA LINK CONNECTOR
ECM (ENGINE CONTROL MODULE)
ECM COMM LINE
FUSE 3
FUSE 6
FUSE BLOCK (J/B)
GRY WIRE
HOT AT ALL TIMES
HOT IN ON OR START
ITS COMM-H
ITS COMM-L
JOINT CONNECTOR
K LINE
LINE
LOW TIRE PRESSURE WARNING CONTROL UNIT
LT BLU WIRE
LT GRN WIRE
NCA WIRE
OCCUPANT DETECTION SYSTEM CONTROL UNIT
PNK WIRE
RED WIRE
RED/WHT WIRE
STEERING ANGLE SENSOR (NEAR STEERING COLUMN)
TCM (TRANSMISSION CONTROL MODULE)
TCU (IF EQUIPPED)
TRANSFER CONTROL UNIT
V CAN-H
V CAN-L
VVEL CONTROL MODULE
WHT WIRE
YEL WIRE
Go to component -> Computer data lines circuit (1 of 3) -> AIR BAG DIAGNOSIS SENSOR UNIT
