Infiniti M37 IV (2010-2014) tire pressure ind ign sig bat pwr sply can-h can-l gnd gnd Wiring diagram
This page shows the only wiring diagram for the component.tire pressure ind ign sig bat pwr sply can-h can-l gnd gnd, which is found in the car Infiniti M37 IV (2010-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram tire pressure ind ign sig bat pwr sply can-h can-l gnd gnd (1 of 1)
25 15 CAN-H CAN-L PNK WIRE
29 39 40 HZD SW CAN-H CAN-L COMPUTER DATA LINES SYSTEM PNK WIRE
408 409 (RIGHT SIDE OF DASH)
70 57 67 BAT (F/L) BAT (FUSE) GND
90 74 81 80 CAN-H CAN-L PNK WIRE
ABS ACTUATOR, ELECTRIC UNIT (CONTROL UNIT) (LEFT REAR OF ENGINE COMPT)
AV CONTROL UNIT (BEHIND CENTER OF DASH)
BCM (BODY CONTROL MODULE) (BEHIND LEFT SIDE OF DASH)
BCM FLASHER
BLK WIRE
BLU WIRE
COMBINATION METER
COMPUTER DATA LINES SYSTEM
FUSE 11
FUSE 3
FUSE 9
FUSE BLOCK (J/B) (BEHIND LEFT END OF DASH) FUSE 4
FUSE, FUSIBLE
FUSIBLE LINK L LINK BLOCK (RIGHT REAR OF ENGINE COMPT)
GRN WIRE
GRY WIRE
HOT AT ALL TIMES
HOT W/ IGNITION RELAY ENERGIZED
IGN
LEFT FRONT TIRE PRESSURE RECEIVER
LEFT REAR TIRE PRESSURE RECEIVER
LOW TIRE PRESSURE WARNING CONTROL UNIT (BEHIND RIGHT SIDE OF DASH)
LT BLU WIRE
ORG/ WIRE
PCB HARNESS
PNK WIRE
PPL
RED WIRE
RIGHT FRONT TIRE PRESSURE RECEIVER
RIGHT REAR TIRE PRESSURE RECEIVER
RSSI
SIG
TAN WIRE
TIRE PRESSURE IND IGN SIG BAT PWR SPLY CAN-H CAN-L GND GND
VCC
W/O NAVIGATION W/ NAVIGATION
WHT WIRE
YEL WIRE
Go to component -> Tire pressure monitoring circuit -> TIRE PRESSURE IND IGN SIG BAT PWR SPLY CAN-H CAN-L GND GND
