Infiniti M37 IV (2010-2014) set/ coast resume/ accelerate wiring diagram
This page shows the only wiring diagram for the component.set/ coast resume/ accelerate, which is found in the car Infiniti M37 IV (2010-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
set/ coast resume/ accelerate wiring diagram (1 of 1)
25 44 30 40 81 91 97 SENS PWR SPLY
3.7L
3.7L 5.6L
48 35 69 89 SENS GND
ACCELERATOR PEDAL POSITION SENSOR (ON ACCELERATOR PEDAL BRACKET)
ASCD BRAKE SWITCH (ON BRAKE PEDAL BRACKET)
ASCD STEERING SWITCH
BLK WIRE
BLU WIRE
BNCSW ASCD SW
BRN WIRE
COMBINATION SWITCH (SPIRAL CABLE)
COMPUTER DATA LINES SYSTEM
ECM (ENGINE CONTROL MODULE) (RIGHT REAR OF ENGINE COMPT)
FUSE 3
FUSE 4
FUSE 50
FUSE 7
FUSE BLOCK (J/B) (BEHIND LEFT END OF DASH)
GRN WIRE
HOT AT ALL TIMES
HOT IN ON OR START
LT BLU WIRE
LT GRN WIRE
MAIN (ON/ OFF) CANCEL
MTR PWR SPLY
MTR RLY
NCA WIRE
ORG/ WIRE
ORG/BLU WIRE
PCB HARNESS
PNK WIRE
PPL
PPL PNK WIRE
PPL THROTTLE CTRL- MTR (BANK 2) (OPEN)
RED WIRE
SENS GND
SENS GND 104 98 129 126 SENS GND
SENS GND 34 2 4 43 79 57 63
SENS PWR SPLY
SENSOR 1
SENSOR 2
SET/ COAST RESUME/ ACCELERATE
STOP LAMP SWITCH (ON BRAKE PEDAL BRACKET)
STOP LP SW
TAN WIRE
THROTTLE CONTROL MOTOR RELAY
WHT WIRE
WHT/BLU WIRE
YEL WIRE
Go to component -> Cruise control circuit (1 of 2) -> SET/ COAST RESUME/ ACCELERATE
