Infiniti M37 IV (2010-2014) high beam ind, fog ind Wiring diagram
This page shows the only wiring diagram for the component.high beam ind, fog ind, which is found in the car Infiniti M37 IV (2010-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram high beam ind, fog ind (1 of 1)
22 20 19 KYLS ENT RECEIVER RSSI KYLS ENT RECEIVER COMM RECEIVER PWR SPLY
46 45 48 47 REAR RH DOOR SW PASSENGER DOOR SW REAR LH DOOR SW DRIVER DOOR SW
70 57 67 BAT (F/L) BAT (FUSE) GND
BCM (BODY CONTROL MODULE) (BEHIND LEFT SIDE OF DASH)
BLK WIRE
BLU WIRE
BRN WIRE
COMBINATION METER
COMBINATION SWITCH
DOOR LOCKS SYSTEM
FUSE 11
FUSE 4
FUSE 9
FUSE BLOCK (J/B) (BEHIND LEFT END OF DASH)
FUSE, FUSIBLE LINK BLOCK (RIGHT REAR OF ENGINE COMPT)
FUSIBLE LINK L
GRN WIRE
GRY WIRE
HIGH BEAM IND, FOG IND
HOT AT ALL TIMES
HOT IN ON OR START
INPUT 1
INPUT 2
INPUT 3
INPUT 4
INPUT 5
LEFT FRONT DOOR SWITCH (AT LEFT "B" PILLAR)
LEFT REAR DOOR SWITCH (AT LEFT "C" PILLAR)
LT BLU WIRE
LT GRN WIRE
OPTICAL SENSOR
OUTPUT
OUTPUT 1
OUTPUT 2
OUTPUT 3
OUTPUT 4
OUTPUT 5
PARKING BRAKE SWITCH (AT BASE OF PARKING BRAKE LEVER)
PCB HARNESS
PNK 1 2 WIRE
PNK WIRE
POWER
PPL
RED WIRE
RIGHT FRONT DOOR SWITCH (AT RIGHT "B" PILLAR)
RIGHT REAR DOOR SWITCH (AT RIGHT "C" PILLAR)
TAN WIRE
WHT WIRE
YEL WIRE
Go to component -> Headlamps circuit (1 of 2) -> HIGH BEAM IND, FOG IND
