Infiniti G37 IV facelift (2006-2013) open output Wiring diagram
This page shows the only wiring diagram for the component.open output, which is found in the car Infiniti G37 IV facelift (2006-2013). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram open output (1 of 1)
67 50 TRUNK LID OPENER SW TRUNK ROOM LAMP SW
90 91 PNK CAN-L CAN-H WIRE
ACTR GND
BAT (F/L)
BAT FUSE
BCM (BODY CONTROL MODULE) (BEHIND RIGHT KICK PANEL)
BLK WIRE
BLU WIRE
BRN WIRE
CAN L
CAN-H
COMPUTER DATA LINES SYSTEM
FUSE (BEHIND LEFT KICK PANEL)
FUSE BLOCK (J/B)
FUSIBLE LINK HOLDER (RIGHT REAR OF ENGINE COMPT)
FUSIBLE LINK O
GRN WIRE
GRY WIRE
HOT AT ALL TIMES
HOT AT ALL TIMES FUSE, FUSIBLE LINK BLOCK FUSIBLE LINK K
ILL
LOCAL COMM
LT BLU WIRE
LT GRN WIRE
MODULE
OF TRUNK)
OPEN OUTPUT
OPENER ACTR
P/W SW, RHT C/U COMM
PNK WIRE
PPL
RED WIRE
REQ SIG
RETRACTABLE HARD TOP CONTROL UNIT (BEHIND LEFT REAR SIDE FINISHER)
ROOM LP SW
STOP SWITCH
STRIKER SWITCH
TAN WIRE
TRUNK CLOSURE CONTROL UNIT (CENTER REAR
TRUNK CLOSURE MOTOR
TRUNK LID OPENER ACTUATOR
TRUNK LID OPENER CANCEL SW
TRUNK LID OPENER CANCEL SWITCH
TRUNK LID OPENER SWITCH
TRUNK ROOM LAMP SWITCH (INTEGRAL TO TRUNK LID LOCK ASSEMBLY)
WHT WIRE
YEL WIRE
Go to component -> Trunk release circuit, convertible -> OPEN OUTPUT
