Infiniti FX50 II (2008-2012) pnk open switch Wiring diagram
This page shows the only wiring diagram for the component.pnk open switch, which is found in the car Infiniti FX50 II (2008-2012). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram pnk open switch (1 of 1)
AS DOOR SW
BACK DOOR CONTROL UNIT (LOWER LEFT SIDE OF BACK DOOR)
BACK DOOR LOCK ASSEMBLY (LOWER CENTER OF BACK DOOR)
BACK DOOR SW
BAT (F/L)
BAT FUSE
BCM (BODY CONTROL MODULE) (RIGHT END OF DASH)
BD OPEN
BK DOOR OPENER SW OPERATION
BLK WIRE
BLU WIRE
CAN-H
CLOSE SW
COMPUTER DATA LINES SYSTEM
DR DOOR UNLOCK SENSOR
DRIVER DOOR LOCK ASSEMBLY (REAR OF DRIVER'S DOOR)
FUSE 10
FUSE 35 LINK L
FUSE BLOCK (J/B) (LEFT KICK PANEL)
FUSE, FUSIBLE LINK BLOCK (RIGHT REAR OF ENGINE COMPT)
FUSIBLE
GRN WIRE
GRY WIRE
HALF LATCH SW
HOT AT ALL TIMES
LEFT "C" PILLAR)
LT BLU WIRE
LT GRN WIRE
MOTOR CLOSE,
OPEN CLOSE HALF BACK SWITCH SWITCH LATCH DOOR SWITCH SWITCH
OPEN/ CLOSE MOTOR
ORG/ WIRE
PNK CAN-L WIRE
PNK OPEN SWITCH WIRE
PNK WIRE
PPL
PPL MOTOR OPEN
RED WIRE
WHT WIRE
Go to component -> Power liftgate circuit -> PNK OPEN SWITCH WIRE
