Car Wiring Diagrams for Manual a/c circuit for Hyundai Veloster II (2018-2024)

2.0L A/C 1 FUSE A/C CONTROL MODULE A/CON A/C COMP FUSE A/CON COMP RELAY AMBIENT TEMP SENS (+) MODE ACTR VENT AMBIENT TEMPERATURE SENSOR BLK WIRE BLOWER INH BLOWER IS BLOWER PWM IN BLU WIRE BLU/RED WIRE BRN WIRE C-CAN HIGH C-CAN LOW CLUTCH COMPUTER DATA LINES SYSTEM DEFOGGER SYSTEM DETENT E/R-A E/R-C ECV GND ECV PWR ELECTRONIC A/C COMPRESSOR (LOWER LEFT FRONT OF ENGINE) EVAPORATOR SENS (+) GRN WIRE GRN/BLK WIRE GRY WIRE GRY/ORG WIRE HOT AT ALL TIMES HOT IN ON HOT IN ON OR START I/P-A I/P-E I/P-F IGPM ILL (+) SENS PWR ILL (-) ON INPUT INTAKE ACTR F/B INTAKE ACTR FRE INTAKE ACTR REC JOINT CONNECTOR UMA LEAK CURRENT AUTO CUT DEVICE MEMORY FUSE MEMORY PWR MODE ACTR DEF MODE ACTR F/B MODULE 5 FUSE MODULE 7 FUSE NCA WIRE ON/START INPUT ORG/ WIRE PCB BLOCK PNK WIRE REAR DEFOGGER SW REAR DEFOGGER SW IND RED WIRE RED/BLK WIRE SENS GND TEMP ACTR (COOL) TEMP ACTR (WARM) TEMP ACTR F/B WHT WIRE WHT/BLK WIRE YEL WIRE

BLK WIRE BLK/ORG WIRE BLOWER FUSE BLOWER MODULE (RIGHT SIDE OF DASH) BLOWER MOTOR BLOWER RELAY BLU WIRE BRN WIRE E/R JUNCTION BLOCK EVAPORATOR SENSOR GRN WIRE GROUND GRY WIRE HOT AT ALL TIMES MOTOR MULTI FUSE 2 ORG/ WIRE PNK WIRE RED WIRE SIGNAL IN SIGNAL INH SIGNAL IS TEMPERATURE ACTUATOR (RIGHT SIDE OF DASH) WHT WIRE YEL WIRE

2.0L A/C PRESSURE TRANSDUCER A/CON COMP RLY B+5 FUSE BLK WIRE BLU WIRE BLU/BLK WIRE BLU/ORG WIRE C-CAN HIGH C-CAN LOW COMPUTER DATA LINES SYSTEM COOLING FAN 1 FUSE COOLING FAN 1 RELAY COOLING FAN 1 RLY CTRL COOLING FAN 2 FUSE COOLING FAN 2 RELAY COOLING FAN 2 RLY CTRL COOLING FAN MOTOR COOLING FAN MOTOR (1.6L TURBO) (BEHIND RADIATOR) E/R JUNCTION BLOCK E/R-A E/R-B E/R-D ECTS GND ECTS SIG ENGINE CONTROL RELAY ENGINE CONTROLS SYSTEM ENGINE CTRL RLY CTRL FAN PWM GRY WIRE HOT AT ALL TIMES MICOM MULTI FUSE 2 NCA WIRE PCB BLOCK PCM (2.0L) ECM (1.6L TURBO) POWER CONDITIONING RED WIRE SENSOR 2 FUSE SENSOR ENGINE COOLANT TEMPERATURE SENSOR SENSOR GND SENSOR PWR SENSOR SIG SR- TEMP WHT WIRE WHT/BLK WIRE YEL WIRE