Hyundai Santa Fe IV facelift (2020-2024) (power back Wiring diagram
This page shows the only wiring diagram for the component.(power back, which is found in the car Hyundai Santa Fe IV facelift (2020-2024). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram (power back (1 of 1)
12.3 INCH LCD
12.3 INCH TFT
BLK WIRE
BLU WIRE
BLU/BLK WIRE
BRN WIRE
C-CAN
C-CAN HIGH
C-CAN LOW
CLUSTER FUSE
COMPUTER DATA LINES SYSTEM
CRASH PAD SWITCH
EPB IND
EPB SW SIG SW 1
EPB SW SIG SW 3
EPB SW SIG SW 4
EPB SWITCH
GRN WIRE
GRN/BLK WIRE
GRY WIRE
GRY/BLK WIRE
ICU JUNCTION BLOCK
ICU-G
IEB 4 FUSE
IEB UNIT
ILL
INSTRUMENT CLUSTER
LCD
LEFT REAR EPB ACTUATOR
LEFT REAR WHEEL SENSOR, EPB ACTUATOR
LIGHT BLOCK
MCU
MICOM
NCA WIRE
ON/START INPUT
ORG/ WIRE
PCB BLOCK
PCB-A
PLUG-IN HYBRID
PNK EPB SW SIG SW 2 WIRE
PNK WIRE
RED WIRE
RELAY ENERGIZED
RIGHT END OF DASH)
RIGHT REAR EPB ACTUATOR
RIGHT REAR WHEEL SENSOR, EPB ACTUATOR
RL MOTOR (-) PNK RL MOTOR (+) WIRE
RR MOTOR -
SIG GND 1
SW 1
SW 1 APPLY
SW 2
SW 2 RELEASE
SW 3
SW 4
TRANSCEIVER/
WHT WIRE
Go to component -> Electric parking brake circuit, hybrid -> (POWER BACK
