Hyundai Santa Fe II facelift (2010-2012) buc gnd Wiring diagram
This page shows the only wiring diagram for the component.buc gnd, which is found in the car Hyundai Santa Fe II facelift (2010-2012). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram buc gnd (1 of 1)
BLFD (-)
BLFP (-)
BLK WIRE
BLU WIRE
BLU/ORG WIRE
BRN WIRE
BRN/BLK WIRE
BRN/ORG WIRE
BTS GND
BTS SIG
BTS-SVOLT
BUC GND
BUC SEN
BUCKLE GND
BUCKLE SNSR
C-CAN HIGH
C-CAN LOW
COMPUTER DATA LINES SYSTEM
DIR PSIS (-)
DRI BELT PRT (-)
DRI PSIS (+)
DRI SAB (+)
DRIVER CURTAIN AIR BAG
DRIVER PRESSURE SIDE IMPACT SENSOR
DRIVER SEAT BELT BUCKLE SWITCH
DRIVER SEAT BELT PRETENSIONER
DRIVER SIDE AIR BAG
DRL CAB (+)
GRN WIRE
GRN/BLK WIRE
GRN/ORG WIRE
GROUND
GRY WIRE
HI LO
LEFT REAR SIDE IMPACT SENSOR
LT GRN WIRE
ON/ST IN
ORG/ WIRE
PASS BELT PRT (+)
PASS CAB (+)
PASS PSIS (+)
PASS SAB (-)
PASSENGER CURTAIN AIR BAG
PASSENGER PRESSURE SIDE IMPACT SENSOR
PASSENGER SEAT BELT BUCKLE SWITCH
PASSENGER SEAT BELT PRETENSIONER
PASSENGER SIDE AIR BAG
PNK WIRE
PODS MODULE (UNDER SEAT)
REAR LH SIS (+)
REAR RH SIS (-)
RED WIRE
RIGHT REAR SIDE IMPACT SENSOR
SEAT BELT TENSION SENSOR
SEAT TRACK POSITION SENSOR
SRS CONTROL MODULE
STPS
WHT WIRE
WHT/BLK WIRE
YEL WIRE
YEL/BLK WIRE
Go to component -> Supplemental restraints circuit (2 of 2) -> BUC GND
