Hyundai Kona I facelift (2020-2024) grip control ind Wiring diagram
This page shows the only wiring diagram for the component.grip control ind, which is found in the car Hyundai Kona I facelift (2020-2024). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram grip control ind (1 of 1)
ABS 1 FUSE
ABS 2 FUSE
ABS 3 FUSE
AUTO HOLD SW
BLK WIRE
BLU WIRE
BLU/ORG WIRE
BRN WIRE
C-CAN HIGH
C-CAN LOW
COMPUTER DATA LINES SYSTEM
DBC (STD) SWITCH
DRIVER CONSOLE SWITCH
E/R JUNCTION BLOCK
EPB SWITCH (SW 1)
EPB SWITCH (SW 3)
EPB SWITCH (SW 4)
EPB SWITCH (SW 6)
ESC MODULE (RIGHT REAR OF ENGINE COMPT)
ESC UNIT
FL SIG
FL VCC
FR SIG
FR VCC
GRIP CONTROL IND
GRN WIRE
GROUND
GRY WIRE
HOT AT ALL TIMES
HOT IN ON OR START
IND
LEFT FRONT WHEEL SENSOR
LEFT REAR WHEEL SENSOR
MULTI FUSE 2
ON/START INPUT
ORG/ WIRE
P-CAN HIGH
P-CAN LOW
PCB BLOCK
RED WIRE
RIGHT FRONT WHEEL SENSOR
RIGHT REAR EPB ACTUATOR
RL (+)
RL SIG
RL VCC
RR (-)
RR SIG
RR VCC
STOP LAMP SWITCH
TRACTION
VBATT
WHEEL SENSOR OUTPUT (FR)
WHT WIRE
YEL WIRE
Go to component -> Anti-lock brakes circuit, w/ epb (1 of 3) -> GRIP CONTROL IND
