Hyundai Genesis II (2013-2016) "p" position atm switch solenoid Wiring diagram
This page shows the only wiring diagram for the component."p" position atm switch solenoid, which is found in the car Hyundai Genesis II (2013-2016). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram "p" position atm switch solenoid (1 of 1)
"P" POSITION ATM SWITCH SOLENOID
ACC INPUT GROUND "P" POS SW 11 12
BLK WIRE
BLK/ORG WIRE
BLU WIRE
BRN WIRE
CRUISE CONTROL SYSTEM
E/R JUNCTION BOX (RIGHT REAR OF ENGINE COMPT)
E/R-CA
E/R-CB
GRN WIRE
HOT AT ALL TIMES LEFT I/P SECURITY JUNCTION BOX LP (LEFT END FUSE OF DASH)
HOT IN ACC OR ON
HOT IN ON OR START
I/P-LHA
I/P-RHB
IPM
JOINT CONNECTOR JMC (RIGHT END OF DASH)
JOINT CONNECTOR JME (BEHIND CENTER OF DASH)
MODULE 2 FUSE
ON/START IN
ORG/ WIRE
PNK WIRE
PNK/BLK WIRE
POWER DISTRIBUTION SYSTEM
RED WIRE
RIGHT I/P JUNCTION BOX (RIGHT END OF DASH)
SPD SIG
SPORT MODE SWITCH
STOP SIG ATM SOLENOID
TRANSMISSION RANGE SWITCH (RIGHT SIDE OF TRANSMISSION)
TRANSMISSIONS SYSTEM
WHT WIRE
WHT/BLK WIRE
YEL WIRE
Go to component -> Shift & key lock circuit -> "P" POSITION ATM SWITCH SOLENOID
