Hyundai Genesis I facelift (2011-2016) cel can- set coast/ Wiring diagram
This page shows the only wiring diagram for the component.cel can- set coast/, which is found in the car Hyundai Genesis I facelift (2011-2016). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram cel can- set coast/ (1 of 1)
45 46 WHEEL SENSOR FL_SIG WHEEL SENSOR FL_GND
ACCEL RESUME/ OFF ON/
BLK WIRE
BLK/ORG WIRE
BLU WIRE
BLU/BLK WIRE
BRN WIRE
C-CAN TRANSCEIVER
CAMERA MODULE (LEFT SIDE OF TRUNK)
CEL CAN- SET COAST/
CLOCK- SPRING
COMPUTER DATA LINES SYSTEM
CRUISE IND
CRUISE SET IND
DATA LINK CONNECTOR (BELOW LEFT SIDE OF DASH)
ESC MODULE (LEFT FRONT OF ENGINE COMPT)
GRN WIRE
GRN/BLK WIRE
GRY/ORG WIRE
ILL
INSTRUMENT CLUSTER
J/C JFRB (RIGHT "C" PILLAR)
J/C JMC (RIGHT END OF DASH)
KEY LOCK MODULE
LEFT REAR WHEEL SENSOR (LEFT REAR WHEEL HUB ASSEMBLY)
LOW 17 18 16 HIGH
MCU
MULTIFUNCTION SWITCH
NCA WIRE
ORG/ WIRE
ORG/BLK WIRE
POWER
REAR CURTAIN MODULE (RIGHT SIDE OF TRUNK)
RED WIRE
RED/BLK WIRE
RESISTOR
RIGHT AUDIO, CRUISE REMOCON SWITCH
RIGHT FRONT WHEEL SENSOR (ON RIGHT FRONT WHEEL HUB ASSEMBLY)
SHIFT
STEERING WHEEL)
SUPPLY
TANT DIS-
TIRE PRESSURE MONITORING MODULE
WHT WIRE
WHT/BLK WIRE
YEL/BLK WIRE
Go to component -> 5.0l, cruise control circuit, without scc (2 of 2) -> CEL CAN- SET COAST/
