Hyundai Elantra V facelift (2013-2016) pnk trunk lid handle switch Wiring diagram
This page shows the only wiring diagram for the component.pnk trunk lid handle switch, which is found in the car Hyundai Elantra V facelift (2013-2016). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram pnk trunk lid handle switch (1 of 1)
2.0L A/T 2.0L M/T
ACC/IN INPUT ON INPUT
B-CAN HIGH B-CAN LOW MEMORY POWER
BLK WIRE
BLU WIRE
BLU/ORG WIRE
BRN/ORG WIRE
COMPUTER DATA LINES SYSTEM
E/R FUSE, RELAY BOX (IN LEFT REAR CORNER OF ENGINE COMPT)
ECM (M/T) PCM (A/T) (LEFT REAR OF ENGINE COMPT)
ENGINE CONTROLS SYSTEM
ENGINE SPEED SIGNAL EMS COM
FUSE
GRN WIRE
GRN/ORG WIRE
GROUND ON/START INPUT PNK WIRE
GROUND TERMINAL CTRL ST RELAY
GRY WIRE
HOT AT ALL TIMES
I/P-F
I/P-H
IMMO DATA LINE
LEFT "C" PILLAR)
MODULE 7 FUSE BCM FUSE PDM 3 FUSE (UNDER LEFT END OF DASH)
NCA WIRE
ORG/ WIRE
ORG/BLK WIRE
PASSENGER TOGGLE BUTTON
PDM 2 (ACC) RELAY
PDM 2 FUSE PDM 1 FUSE
PDM 3
PDM 4
PNK TRUNK LID HANDLE SWITCH WIRE
PNK WIRE
POWER DISTRIBUTION SYSTEM
RED WIRE
RELAY
SMART JUNCTION BOX
SMART KEY CONTROL MODULE (RIGHT REAR OF DASH)
STARTING/ CHARGING SYSTEM
TERMINAL CONTROL ACC RELAY
TRUNK LID HANDLE SWITCH
WHT WIRE
YEL WIRE
YEL/BLK WIRE
YEL/ORG WIRE
Go to component -> Immobilizer circuit, with smart key system (1 of 3) -> PNK TRUNK LID HANDLE SWITCH WIRE
