Hyundai Accent II facelift (2002-2005) stop lp sig in whl spd in whl spd in wiring diagram
This page shows the only wiring diagram for the component.stop lp sig in whl spd in whl spd in, which is found in the car Hyundai Accent II facelift (2002-2005). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
stop lp sig in whl spd in whl spd in wiring diagram (1 of 1)
ABS IND CTRL
ABS IND.
BLK WIRE
BLU WIRE
BRN WIRE
DASH FUSE BOX (BEHIND LEFT KICK PANEL)
DATA LINK CONNECTOR (AT LOWER LEFT SIDE OF DASH)
FUSE 13
FUSE 2
FUSE 8
FUSIBLE LINK 1 (ABS)
FUSIBLE LINK 2 (ABS)
GRN WIRE
GRN/BLK WIRE
HOT AT ALL TIMES
HOT IN ON OR START
INSTRUMENT CLUSTER
JOINT CONNECTOR
LEFT FRONT WHEEL SENSOR (ON STEERING KNUCKLE)
LEFT REAR WHEEL SENSOR (ON AXLE CARRIER ASSEMBLY)
NCA WIRE
ON INPUT WHL SPD IN WHL SPD IN DIAGNOSIS GROUND MEM POWER
ORG/ WIRE
PNK/BLK WIRE
PRE- EXCITATION RESISTOR (IN ENGINE COMPT RELAY & FUSE BOX)
RED WIRE
RIGHT FRONT WHEEL SENSOR (ON STEERING KNUCKLE)
RIGHT REAR WHEEL SENSOR (ON AXLE CARRIER ASSEMBLY)
STOP LP SIG IN WHL SPD IN WHL SPD IN
STOPLAMP SWITCH (ON BRAKE PEDAL SUPPORT)
WHL SPD IN WHL SPD IN GROUND MEM POWER
WHT WIRE
YEL WIRE
Go to component -> Anti-lock brakes circuit -> STOP LP SIG IN WHL SPD IN WHL SPD IN
