Hummer H2 I facelift (2007-2009) of dash behind end trim panel) Wiring diagram
This page shows the only wiring diagram for the component.of dash behind end trim panel), which is found in the car Hummer H2 I facelift (2007-2009). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram of dash behind end trim panel) (1 of 1)
5-VOLT REFERENCE
AIR BAG IGN FUSE 34
AUX HVAC IGN FUSE 41
AUXILIARY AIR TEMPERATURE ACTUATOR
AUXILIARY MODE ACTUATOR
BLK WIRE
BODY CONTROL MODULE (BCM)
DK BLU WIRE
ENGINE CONTROL MODULE (ECM)
FROM PWR/TRN PCB RELAY (DIAGRAM 3 OF 4)
HVAC IGN FUSE 46
IGN
IGNITION SWITCH
INFLATABLE RESTRAINT I/P MODULE DISABLE SWITCH
INFLATABLE RESTRAINT PASSENGER AIR BAG ON/OFF INDICATOR
INFLATABLE RESTRAINT SENSING, DIAGNOSTIC MODULE (SDM)
INSIDE REARVIEW MIRROR (ISRVM)
INSTRUMENT PANEL CLUSTER (IPC)
KEY IGNITION SWITCH
LEFT MODE AIR ACTUATOR TEMPERATURE ACTUATOR
MISC IGN FUSE 37
NCA WIRE
OF DASH BEHIND END TRIM PANEL)
OFF
ORG/ WIRE
PNK PNK WIRE
PNK WIRE
REARVIEW CAMERA (IF EQUIPPED)
RECIRCULATION ACTUATOR
RED WIRE
RED/WHT WIRE
RIGHT AIR TEMPERATURE ACTUATOR
RIGHT I/P JUNCTION BLOCK (RIGHT SIDE
RUN WIRE
RUN/CRNK RELAY
SEO FUSE 45
THEFT DETERRENT MODULE (TDM)
TO ECM IGN FUSE (DIAGRAM 2 OF 4)
TRANSFER CASE SHIFT CONTROL MODULE
TRANSMISSION CONTROL MODULE (TCM)
WHT WIRE
YEL WIRE
Go to component -> Power distribution circuit (4 of 4) -> OF DASH BEHIND END TRIM PANEL)
