Hummer H2 I facelift (2007-2009) ignition iii voltage Wiring diagram
This page shows the only wiring diagram for the component.ignition iii voltage, which is found in the car Hummer H2 I facelift (2007-2009). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram ignition iii voltage (1 of 1)
5-VOLT REFERENCE
AUTOMATIC TRANSMISSION
BATTERY
BATTERY CABLE JUNCTION BLOCK (PART OF POSITIVE BATTERY CABLE ASSEMBLY)
BLK WIRE
COMPUTER DATA LINES SYSTEM
CONTROL SOLENOID VALVE ASSEMBLY
DATA BUS -
ENGINE COMPT, NEAR BATTERY)
IGNITION III VOLTAGE
IGNITION SWITCH
INTERNAL MODE P/N SWITCH (IMS)
OFF
ORG/BLK WIRE
PARK NEUTRAL SIGNAL
PNK/BLK WIRE
PPL
RED WIRE
RUN WIRE
STARTER
STARTER ENABLE RELAY CTRL
STRTR FUSE 54
STRTR RELAY
TAN WIRE
TAN/BLK WIRE
UNDERHOOD FUSE BLOCK (AT LEFT SIDE OF
WHT WIRE
YEL/BLK WIRE
Go to component -> Starting circuit -> IGNITION III VOLTAGE
