Hummer H2 I facelift (2007-2009) cooling fan diode Wiring diagram
This page shows the only wiring diagram for the component.cooling fan diode, which is found in the car Hummer H2 I facelift (2007-2009). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram cooling fan diode (1 of 1)
A/C COMPRESSOR CLUTCH
A/C LOW IGNITION PRESSURE COIL/ SWITCH MODULE 8
AMBIENT LIGHT/ SUNLOAD SENSOR
BATTERY
BLK WIRE
BLK/WHT WIRE
BODY CONTROL MODULE (BCM)
COMPT, NEAR BATTERY)
COOLING FAN DIODE
DATA LINK CONNECTOR (DLC)
DRIVER DOOR LOCK/ REAR DOOR WINDOW LOCK/UNLOCK SWITCH PCB RELAY
ENGINE CONTROL MODULE AUTOMATIC TRANSMISSION (ECM)
FAN CONTROL RELAY
FRT WASH PCB RELAY
HARNESS JUNCTION TO ENGINE HARNESS)
HEADLAMP, PANEL DIMMER SWITCH
I/P FUSE BLOCK (ON LOWER LEFT SIDE OF I/P, BEHIND ACCESS PANEL)
I/P MULTIFUNCTION SWITCH
IGNITION COIL/ MODULE 2
IGNITION IGNITION COIL/ COIL/ MODULE 1 MODULE 3
IGNITION IGNITION COIL/ COIL/ MODULE 4 MODULE 6
IGNITION IGNITION COIL/ COIL/ MODULE 5 MODULE 7
LEFT DAYTIME RUNNING LAMP (DRL)
LEFT FRONT PARK/TURN SIGNAL LAMP
LEFT HEADLAMP
LEFT HORN
MASS AIR FLOW (MAF)/ INTAKE AIR TEMPERATURE (IAT) SENSOR
NCA WIRE
REAR WASH PCB RELAY
REMOTE CONTROL HVAC DOOR LOCK CONTROL RECEIVER MODULE (RCDLR)
RIGHT DAYTIME RUNNING LAMP (DRL)
RIGHT ENGINE COOLING FAN
RIGHT FRONT PARK/TURN SIGNAL LAMP
RIGHT HEADLAMP
RIGHT HORN
RUN/ ACCY RELAY
RUN/ REAR BACK-UP CRANK DEFOG STARTER LAMP PCB RELAY RELAY RELAY RELAY
THEFT TURN SIGNAL/ DETERRENT MULTIFUNCTION MODULE SWITCH (TDM)
TRANSFER (SUT) CASE SHIFT HOOD MID GATE CONTROL AJAR WINDOW MODULE SWITCH SWITCH
UNDERHOOD FUSE BLOCK (AT LEFT SIDE OF ENGINE
UNDERHOOD FUSE BLOCK (AT LEFT SIDE OF ENGINE COMPT, NEAR BATTERY)
WINDSHIELD WASHER FLUID LEVEL SWITCH
WIPER CONTROL PCB RELAY
Go to component -> Ground distribution circuit (1 of 3) -> COOLING FAN DIODE
