Hummer H2 I facelift (2007-2009) 1 2 bat pos volt gnd Wiring diagram
This page shows the only wiring diagram for the component.1 2 bat pos volt gnd, which is found in the car Hummer H2 I facelift (2007-2009). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram 1 2 bat pos volt gnd (1 of 1)
1 2 3 4 5 6 WSH FLD HTD CTRL SW SW INDICATOR CTRL
1 2 BAT POS VOLT GND
BLK WIRE
BODY CONTROL MODULE (BCM) (ON LOWER LEFT SIDE DASH, TO LEFT OF STEERING COLUMN)
FRONT WIPER/ WASHER CIRCUIT
GND WSH SW SIG IGNITION VOLT PNK WIRE
HEADLAMP, PANEL DIMMER SWITCH
HOT AT ALL TIMES
IGN VOLT
LT GRN WIRE
NCA WIRE
ORG/ WIRE
PPL/WHT WIRE
RED/BLK WIRE
UNDERHOOD FUSE BLOCK (AT LEFT SIDE OF ENGINE COMPT, NEAR BATTERY)
WASHER FLUID HEATED CONTROL SWITCH
WINDSHIELD WASHER SOLVENT HEATER (LEFT REAR CORNER OF ENGINE COMPT)
WINDSHIELD WASHER SOLVENT HEATER SWITCH INDICATOR
WSW/HTR FUSE 57
Go to component -> Heated windshield washer circuit -> 1 2 BAT POS VOLT GND
