Honda Pilot II facelift (2011-2015) (w/ honda accessory) remote starting control unit wiring diagram
This page shows the only wiring diagram for the component.(w/ honda accessory) remote starting control unit, which is found in the car Honda Pilot II facelift (2011-2015). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(w/ honda accessory) remote starting control unit wiring diagram (1 of 1)
A/C CONDENSER FAN MOTOR
A/T CLUTCH PRESSURE CONTROL SOLENOID VALVE A
AUXILIARY UNDER-HOOD FUSE/RELAY BOX
BATTERY
BLK WIRE
BRAKE FLUID LEVEL SWITCH
BRN WIRE
CMP CKP SENSOR SENSOR
EGR VALVE, EGR VALVE POSITION SENSOR PCM
ENGINE
FRONT A/F SENSOR
FRONT SECONDARY
GND (PGMETCS)
GND GND
IGNITION COIL 3
IGNITION IGNITION IGNITION COIL COIL COIL
J/C
KNOCK SENSOR SHIELD
LEFT FRONT LEFT FRONT TURN SIGNAL/ SIDE MARKER PARKING LIGHT LIGHT
LEFT HEADLIGHT
MISSION)
NCA WIRE
PCM
REAR A/F SENSOR
REAR SECONDARY
REAR WINDOW WIPER MOTOR RELAY 1 (FORWARD)
REAR WINDOW WIPER MOTOR RELAY 2 (BACKWARD)
RIGHT FRONT SIDE MARKER LIGHT
ROCKER ARM OIL CONTROL IGNITION IGNITION SOLENOID B COIL 1 COIL 2 (BANK 1)
ROCKER ARM OIL CONTROL SOLENOID A (BANK 1)
SHIELD
TRANS- MISSION RANGE SWITCH
TRANSMISSION HOUSING)
VSA MODULATOR CONTROL UNIT
WINDSHIELD WIPER MOTOR
Go to component -> Ground distribution circuit (1 of 5) -> (W/ HONDA ACCESSORY) REMOTE STARTING CONTROL UNIT
