Honda Accord IX (2012-2016) pedal force simulator valve Wiring diagram
This page shows the only wiring diagram for the component.pedal force simulator valve, which is found in the car Honda Accord IX (2012-2016). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram pedal force simulator valve (1 of 1)
BLK WIRE
BLU WIRE
BRAKE PEDAL STROKE SENSOR (ON BRAKE PEDAL SUPPORT)
BRAKE SYSTEM INDICATOR (LED)
BRAKE WARNING INDICATOR (LED)
BRN WIRE
CIRCUIT
COMPUTER DATA LINES SYSTEM
CONVERTER)
CPU/POWER SUPPLY CIRCUIT/CONTROLLER AREA NETWORK CONTROL
DC-DC
DRIVER'S DOOR SWITCH (AT LEFT "B" PILLAR)
ELECTRIC SERVO BRAKE CONTROL UNIT (RIGHT END OF DASH)
EXCEPT PLUG-IN HYBRID
F-CAN
F-CAN H
F-CAN L
FORCED
FUSE 10
FUSE 2-2
FUSE 21
FUSE 5
GAUGE CONTROL MODULE
GRN WIRE
GRY WIRE
HOT AT ALL TIMES
HOT W/
INDICATOR DRIVER CIRCUIT
LOWER HYDRAULIC PRESSURE SENSOR
LT BLU WIRE
LT GRN WIRE
MASTER CUT VALVE
MICU
MOTOR
MOTOR ANGLE SENSOR
OF DASH)
ORG/ WIRE
PCM (LEFT FRONT OF ENGINE COMPT)
PEDAL FEEL SIMULATOR (LEFT REAR OF ENGINE COMPT)
PEDAL FORCE SIMULATOR VALVE
PLUG-IN HYBRID EXCEPT PLUG-IN HYBRID
PNK WIRE
PPL
RED WIRE
TANDEM MOTOR CYLINDER (RIGHT REAR OF ENGINE COMPT)
TRANSCEIVER/
TURNING-ON
UNDER-HOOD FUSE/RELAY BOX (LEFT REAR OF ENGINE COMPT)
UPPER HYDRAULIC PRESSURE SENSOR
WHT WIRE
YEL WIRE
Go to component -> Electric servo brake system circuit, hybrid -> PEDAL FORCE SIMULATOR VALVE
