GMC Yukon III (2006-2014) (endgate harness, 5 cm from rear view camera breakout) wiring diagram
This page shows the only wiring diagram for the component.(endgate harness, 5 cm from rear view camera breakout), which is found in the car GMC Yukon III (2006-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(endgate harness, 5 cm from rear view camera breakout) wiring diagram (1 of 1)
6 7 CAMERA SIG + CAMERA SIG -
7 6 15 5 CAMERA SIG - CAMERA SIG + (OR PNK) WIRE
BACKUP LP CTRL
BLK/WHT WIRE
BODY CONTROL MODULE (BCM) (LEFT SIDE OF DASH)
BREAKOUT)
CAMERA VID SIG (+)
DK BLU WIRE
DRAIN WIRE
GROUND
GRY WIRE
HOT W/ RUN/ CRNK RELAY ENERGIZED
IGNITION VOLTAGE
LOGIC INSIDE REARVIEW MIRROR (ISRVM)
LT BLU WIRE
MIRROR DISPLAY
MISC-IGN FUSE 43
NCA WIRE
PNK PNK WIRE
PNK WIRE
POWER DISTRIBUTION SYSTEM
RADIO
REARVIEW CAMERA (MIDDLE OF LIFTGATE)
REVERSE SIGNAL
UNDERHOOD FUSE BLOCK (LEFT SIDE OF ENGINE COMPT)
W/O RADIO
W/O UYS W/ UYS
WHT WIRE
Go to component -> Rear view camera circuit, without one piece liftgate -> (ENDGATE HARNESS, 5 CM FROM REAR VIEW CAMERA BREAKOUT)
