GMC Yukon III (2006-2014) air inlet driver motor battery temperature sensor wiring diagram

1 2 3 4 NOT USED MTR PWR FEED GROUND 5-VOLT REF 2 3 7 5-VOLT REF NOT USED RLY CONTROL 6 17 DATA BUS + DATA BUS - 8 36 56 51 72 PUMP MTR GND LOW REF 5-VOLT REF DATA BUS - DATA BUS + AIR INLET DRIVER MOTOR BATTERY TEMPERATURE SENSOR AIR OUTLET DRIVER MOTOR BATTERY TEMPERATURE SENSOR AUXILIARY FUSE BLOCK BECM FAN FUSE 2 BLK WIRE BLK/YEL WIRE BLU WIRE COMPUTER DATA LINES SYSTEM COOL PUMP FUSE 6 COOL PUMP RELAY DK BLU WIRE DK GRN WIRE DK GRN/BLK WIRE DRIVE MOTOR GENERATOR BATTERY (UNDER REAR OF VEHICLE) DRIVER MOTOR BATTERY DRIVER MOTOR BATTERY TEMPERATURE SENSOR 3 DRIVER MOTOR BATTERY TEMPERATURE SENSOR 4 DRIVER MOTOR GENERATOR BATTERY CONTROL MODULE ENGINE CONTROL MODULE (ECM) (LEFT FRONT OF ENGINE COMPT) GENERATOR BATTERY VENT FAN RELAY GENERATOR CONTROL MODULE TEMPERATURE SENSOR (RIGHT FRONT OF ENGINE COMPT) GRN WIRE HOT AT ALL TIMES LEFT GENERATOR CONTROL MODULE COOLANT PUMP (LEFT FRONT OF ENGINE COMPT) LOGIC GENERATOR BATTERY VENT FAN ORG/ WIRE PNK/DK BLU WIRE RED WIRE RED/WHT WIRE RIGHT GENERATOR CONTROL MODULE COOLANT PUMP (CENTER FRONT OF ENGINE COMPT) TAN WIRE TAN/BLK WIRE TEMPERATURE SENSOR 1 TEMPERATURE SENSOR 2 WHT WIRE WHT/GRN WIRE YEL WIRE