GMC Yukon I (1991-1999) vehicle control module (vcm) (in engine compt, on left fender) wiring diagram
This page shows the only wiring diagram for the component.vehicle control module (vcm) (in engine compt, on left fender), which is found in the car GMC Yukon I (1991-1999). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
vehicle control module (vcm) (in engine compt, on left fender) wiring diagram (1 of 1)
4000 PULSES/MILE CRUISE STATUS
BLK WIRE
BLK/WHT WIRE
BLU WIRE
BRAKE FUSE 18 STOP/HAZ FUSE 1
BRN WIRE
BRN/WHT WIRE
CLUTCH PEDAL SWITCH (TOP OF CLUTCH PEDAL)
CRUISE CONTROL MODULE (FRONT OF ENGINE COMPT NEAR LEFT FENDER)
CRUISE CONTROL SWITCH
CRUISE FUSE 6
CRUISE ON INPUT SET/COAST INPUT RESUME/ACCEL INPUT
CRUISE STATUS VEHICLE SPEED INPUT
DISENGAGE INPUT GROUND IGNITION BRAKE APPLIED INPUT
DK BLU WIRE
DK GRN/WHT WIRE
GRY WIRE
GRY/BLK WIRE
HOT AT ALL TIMES
HOT IN RUN
I/P FUSE BLOCK
LT BLU/BLK WIRE
LT GRN/BLK WIRE
M/T A/T
OFF
OR 379 451
ORG/ WIRE
PPL
PPL/WHT WIRE
R/A
S/C DK
TCC/STOPLAMP BRAKE SWITCH (TOP OF BRAKE PEDAL)
VEHICLE CONTROL MODULE (VCM) (IN ENGINE COMPT, ON LEFT FENDER)
VEHICLE SPEED SENSOR (VSS) (LEFT SIDE OF TRANSMISSION)
VSS RETURN
VSS SIGNAL
WHT WIRE
Go to component -> 5.7l (vin r), cruise control circuit -> VEHICLE CONTROL MODULE (VCM) (IN ENGINE COMPT, ON LEFT FENDER)
