GMC Terrain I (2009-2015) key capture solenoid actuator (next to ignition switch) wiring diagram
This page shows the only wiring diagram for the component.key capture solenoid actuator (next to ignition switch), which is found in the car GMC Terrain I (2009-2015). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
key capture solenoid actuator (next to ignition switch) wiring diagram (1 of 1)
BATT POS VOLT
BODY CONTROL MODULE (LOWER LEFT SIDE OF DASH)
BRAKE PEDAL POSITION SENSOR (TOP OF BRAKE PEDAL ASSEMBLY)
BRN WIRE
BRN/WHT WIRE
COMPUTER DATA LINES SYSTEM
ENGINE CONTROL MODULE (LEFT FRONT OF ENGINE COMPT)
GRY WIRE
HOT AT ALL TIMES
HOT AT ALL TIMES INSTRUMENT PANEL FUSE BLOCK (RIGHT CENTER OF DASH) DLIS FUSE
IGNITION CYLINDER LOCK CONTROL SWITCH
KEY CAPTURE SOLENOID ACTUATOR (NEXT TO IGNITION SWITCH)
KEY IN IGNITION SWITCH IGNITION SWITCH
LOW REF
OFF
PNK IGN VOLT WIRE
PNK WIRE
PPL/WHT WIRE
RED/WHT WIRE
RUN WIRE
RVC BATT SNSR FUSE
TAN WIRE
TAN/BLK WIRE
TRANSMISSION SHIFT LEVER
UNDERHOOD FUSE BLOCK (LEFT REAR OF ENGINE COMPT)
WHT WIRE
YEL WIRE
Go to component -> Ignition lock solenoid circuit -> KEY CAPTURE SOLENOID ACTUATOR (NEXT TO IGNITION SWITCH)
