Ford Windstar I (1994-2003) (heater blower motor feed harness, near breakout to blower motor resistor) wiring diagram
This page shows the only wiring diagram for the component.(heater blower motor feed harness, near breakout to blower motor resistor), which is found in the car Ford Windstar I (1994-2003). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(heater blower motor feed harness, near breakout to blower motor resistor) wiring diagram (1 of 1)
BATTERY JUNCTION BOX (LEFT SIDE OF ENGINE COMPARTMENT)
BLK WIRE
BLK/LT GRN WIRE
BLK/ORG WIRE
BLOWER MOTOR (BEHIND RIGHT SIDE OF DASH)
BLOWER MOTOR RESISTOR (BEHIND RIGHT SIDE OF DASH)
BLOWER MOTOR SWITCH
BLU WIRE
BRN/WHT WIRE
CENTRAL JUNCTION BOX (BEHIND LEFT SIDE OF DASH)
COOLING FAN DROPPING RESISTOR (ON LOWER LEFT FRONT OF ENGINE COMPARTMENT)
DK BLU WIRE
ENGINE COOLING FAN MOTOR HIGH SPEED RELAY
ENGINE COOLING FAN MOTOR LOW SPEED RELAY
FRONT BLOWER MOTOR RELAY
FUSE 107
FUSE 120
FUSE 20
HOT AT ALL TIMES
HOT IN START OR RUN
LEFT ELECTRIC COOLING FAN MOTOR (BEHIND LEFT SIDE OF RADIATOR)
LT BLU WIRE
LT GRN WIRE
LT GRN/VIO WIRE
NCA WIRE
ORG/ WIRE
ORG/LT GRN WIRE
PNK WIRE
PNK/WHT WIRE
RED WIRE
RED/ORG WIRE
RIGHT ELECTRIC COOLING FAN MOTOR (BEHIND RIGHT SIDE OF RADIATOR)
WHT WIRE
Go to component -> Manual a/c circuit (2 of 2) -> (HEATER BLOWER MOTOR FEED HARNESS, NEAR BREAKOUT TO BLOWER MOTOR RESISTOR)
